Subaru XT 1988 Service Manual page 91

1-5 PERIODIC MAINTENANCE SERVICES
2) Check the fluid level by removing filler cap of oil pump. •
Except XT6
(1) Check at temperature 21°C (70°F) of fluid temper-
ature.
A3-285
Fig. 61
(2) Check at temperature 60°C (140°F) of fluid temper-
ature.
A3-286
Fig. 62
3) Fluid level should be maintained in the each specified
range on the indicator of filler cap.
If fluid level is at lower point or below, add fluid to keep the
level in the specified range of i nd icator.
If fluid level is at upper point or above, drain fluid to keep the
level in the specified range of indicator by using a syri.nge or
the like.
Recommended fluid Manufacturer
B.P.
CAlTEX
CASTROl
ATF Dexron II
MOBil
SHEll
TEXACO
• XT6
32
IDEMITSU
Fluid capacity:
Recommended fluid
SPECIAL POWER STEERING FLUID
[Parts No. K0209A0080]
0.7£ (1.5 US pt, 1.2 Imp pt)
POWER STEERING FLUID FOR LEAKS
Inspect the underside of oil pump and gearbox for power
steering system, hoses, piping and their couplings for fluid
leaks.
If fluid leaks are found, correct them by retightening their
fitting bolts (or nuts) and/or replacing their parts.
a. Wipe the leakage fluid off after correcting fluid leaks, or a
wrong diagnosis is taken later.
b. Also pay attention to clearances between hoses (or pipings)
and other parts when inspecting fluid leaks.