Installation Of Steering Components - Subaru XT 1988 Service Manual

PRE-DELIVERY INSPECTION 1-4
Hazard warning light switch
18. INSTALLATION OF STEERING
When the switch knob is pushed, all turn-signal lights flash as
COMPONENTS
a hazard warning regardless of the ignition switch position
for use in an emergency stop with the ignition either off or on.
To stop flashing, push the opposite knob.
Turn signals do not function when the hazard warning switch
is on.
Avoid leaving the lights on for long time as it discharges the
battery.
( rrr:-=================----;-L-:-' - 4:-;' S O
Fig. 47
Parking light switch
When the switch knob is pushed, the parking lights all go on
regardless of the ignition switch position.
(
(~r-===============:-~I
- ; - : L
' ; - - : - 4 ~ S 1
Fig.
48
15
CHECK POINTS
,. I nstallation of universal joints
2. Steering gear box for looseness, play, or
backlash, and boots for damage
3. Tie-rod and tie-rod end for proper installa-
tion, or damage
1. Check the universal joint for looseness.
Tightening torque:
21 - 26 N·m (2.1 - 2.7 kg·m, 15 - 20 ft·lb)
Fig. 49
When checking, turn IG switch to "ACC" position.
2. Check the gear box mounting bolt for looseness.
Tightening torque:
47 - 71 N'm (4.8 - 7.2 kg-m, 35 - 52 ft·lb)
Fig. 50