Aizpn: Assignment Of Internal Zone Paging Data For Ndm - NEC NEAX 7400 IMX Command Manual

AIZPN: Assignment of Internal Zone Paging Data for NDM

1. General
This command is used to assign Internal Zone Paging group data in Netfusing Network. The data assigned by
this command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating
the NDM at each Local Node (LN).
2. Precautions
1. Each Internal Zone Paging group must be composed of
2. A maximum of 255 Internal Zone Paging groups can be assigned in one Netfusing Network.
3. A maximum of 24 stations can be assigned to one Internal Zone Paging group.
term
4. One station can be assigned to multiple Internal Zone Paging group.
D
5. It is not available to arrange the member stations of an Internal Zone Paging group stretching over multi-
ple Nodes.
6. This command is available since Release 9 software enhancement.
3. Data Entry Instructions
NIZPG
Enter the Internal Zone Paging group
code in the Netfusing Network with a
range from 1 to 255.
NETWORK
INTERNAL
ZONE PAGING
GROUP ID
(NIZPG)
1-255
The number of digit for Internal Zone Paging group ID is determined by the ASYDL/N SYS1, INDEX804,
Note:
b3 0/1: 2 digits/3 digits.
Note
UGN
1
1
UGN
Fixed to "1."
term
station (TEC=12).
D
TELN
Enter the Telephone Number of the
member stations within Internal
Zone Paging Group.
TELEPHONE NUMBER
(TELN)
MAX. 16 DIGITS
ND-70348 (E)
AIZPN
REMARKS
CHAPTER 4
Page 378
Revision 3.0