Remote Pim Over Ip Data Assignment - NEC NEAX2000 IPS System Manual

CÔNG TY VIỄN THÔNG VIỆT PRO

REMOTE PIM OVER IP DATA ASSIGNMENT

Remote PIM over IP System Setup
(1) Procedure of Initial Operation
STEP1: Assign all required system data to the MP card of Main Site, including the required data for Re-
mote Site (CM0B Y=31-60).
STEP2: Load all Key FD data to the Main Site.
For details, refer to Key FD Operation Guide.
STEP3: Execute the system data backup to the Flash ROM of MP card by CMEC Y=6>0:0.
STEP4: Save the system data of Main Site by MATWorX.
STEP5: Clear the system memory of Remote Site by CM00>1.
STEP6: Load the system data saved in STEP4 to all Remote Sites using MATWorX.
STEP7: Assign the Remote Site numbers to each MP card of Remote Sites by CM0B Y=00>90.
Page 119
STEP8: Confirm that the link between Main Site and Remote Site is established.
If not, connect the Main Site and Remote Site by LAN.
– The required system data is copied to each Remote Site from the Main Site, and Remote Sites
starts.
CHAPTER 3 SYSTEM DATA PROGRAMMING
Chuyên phân phối tổng đài NEC
[For other than North America]
– 96 –
http://vietpro.com.vn
REMOTE PIM OVER IP DATA ASSIGNMENT
ND-71503(E) Rev.5.0
9pch3001.fm
JANUARY/16/2004