ATGL: Assignment of Trunk Group Busy Lamp Data
1. General
This command is used to assign the data related to the Trunk Group Busy Lamp which is accommodated on the
Attendant Console.
2. Precautions
1.
The maximum number of Attendant Consoles should be assigned by the ASYD command, SYS 1, INDEX
9.
2.
The Trunk Group Busy Lamp is lit when the trunk routes specified by the RT parameter of this command
are engaged.
3.
The number of Trunk Group Busy Lamps to be applied (capable TGN data range) is designated by the
ASYD command, SYS1, INDEX15, bit0-3.
3. Data Entry Instructions
ATN
Attendant Console number assigned by
the ATRK command
ATTENDANT
NUMBER
(ATN)
TRUNK
ROUTE
NUMBER
GROUP
(RT)
(TGN)
1-10
Enter the route number composed the TGN
ND-70348 (E)
REMARK
RT
ATGL
CHAPTER 4
Page 466
Revision 3.0