NEC NEAX 7400 IMX Command Manual page 404

FUNCTION
OC 0= -
24
1=Originating Category Information is used
R/L Attendant-Identification of Incoming Trunk Display.
25 0= TN, RT, TK display
1= C.O. Line Number display
RVSD Trunk Reversal Identification
This data is necessary when a specific Trunk route provides battery
26 reversal for answer super-vision.
0= Battery Reversal System
1= Third Wire System
27 TL Tone Level
ANS Answer signal from Trunk side.
28 0= No answer signal is given.
1= Answer signal is given.
TELP Time Elapse Indication Service
0= Out of Service
29
PAD This data determines Pad control on the ODT/DTI circuit card.
TLT (EMT)
30 0= Depending on setting.
7= Pad Off(0db)
OGRL Release timing for outgoing trunk connection.
0= 608 msec.
2= 288 msec.
4= 416 msec.
31 6= 544 msec.
8= 672 msec.
10= 800 msec.
12= 928 msec.
14= 1056 msec.
RT
1= In Service
DTI
–
Pad Off(0db)
1= 224 msec.
3= 352 msec.
5= 480 msec.
7= 608 msec.
9= 736 msec.
11= 864 msec.
13= 992 msec.
15= 1120 msec.
ND-70348 (E)
REMARKS
For MFC signaling
(Brazil and Mexico)
0 0 0 0 Always assign data "0".
TELP (Time Elapse Indica-
tion) is a warning tone sent
to the caller after a predeter-
mined period of time has
elapsed (usually three min-
utes).
Pad=1-6: Actual PAD value
depends on PAD ROM on
the ODT/DTI circuit card.
(See the "Circuit Card Man-
ual")
• Normally assign
data "0"
• For ISDN, see Ta-
ble 4-21
407)
of Route Class
Settings)
ARTD
(page
. (Examples
CHAPTER 4
Page 397
Revision 3.0