Adpcn: Assignment Of Determinate Point Code Data For Ndm - NEC NEAX 7400 IMX Command Manual

ADPCN: Assignment of Determinate Point Code Data for NDM

1. General
This command is used to assign the destination Point Code (PC) for CCIS interface within Netfusing - CCIS
incorporating network. The data assigned by this command is written in the Network Data Memory (NDM) of
the Network Control Node (NCN), upgrading the NDM of each Local Node (LN).
2. Precautions
1. A unique PC must be given to a node in the CCIS network. The OPC (Originating Point Code ) is desig-
nated by the ASYD command, SYS1, INDEX180 and 181.
2. The PC is the decimal value from 1 to 16367 in CCIS network.
3. The PC assigned by this command should correspond to the one assigned by the ACIC1N/ACIC2 com-
mand.
4. Once assigning the destination PC data for CCIS interface by this ADPCN (NDM) command, the existing
CCIS/ISDN data in DM and LDM turns invalid.
5. This command is available for the software Release 11 or later.
3. Data Entry Instructions
For CCIS, assign the Logical route number of speech route.
LOGICAL ROUTE NUMBER
(LGRT) 1-899
LRGT
DETERMINATE POINT
CODE (PC) 1-16383
For CCIS, enter the PC of destination node.
ND-70348 (E)
REMARKS
PC
ADPCN
CHAPTER 4
Page 486-1
Revision 5.0