Avips: Assignment Of Voip-Pkg Detailed Data With Software - NEC NEAX 7400 IMX Command Manual

AVIPS: Assignment of VoIP-PKG detailed Data with Software

1. General
This command is used to assign/delete the detailed data of IPTRK card such as Jitter Buffer, Payload Type/Size,
FAX mode by software. The data can be assigned on a circuit basis by specifying the LENS. The detailed data
is categorized in the following two types:
i. Voice Data (for FCCS/CCIS/H.323)
ii. Signal Data (for H.323 only)
2. Precautions
1. AVIPS and AGIP commands cannot be used simultaneously.
2. IPTRK related data specified by the LENS must be assigned by the AGIP command in advance.
3. The assignment on this command has priority over the switch setting on the IPTRK card.
4. This command is available since Release 10 software enhancement for IPX only.
3. Data Entry Instructions
LENS
Enter the LENS of IPTRK
(PA-16IPTC) card.
LINE
EQUIPMENT
NUMBER
SELECTION
(LENS)
MG U G
* Continued on the next page.
The kind, IPTRK (FCCS), IPTRK (CCIS), or
IPTRK (H.323), assigned by the AGIP command
is displayed. (Display only. It cannot be modified
here.)
KIND OF
(KIND)
KIND
ND-70348 (E)
AVIPS
CHAPTER 4
Page 642-2
Revision 5.0