NEC NEAX 7400 IMX Command Manual page 658

3. Data Entry Instructions
FPC is the unique number allocated
to each node.
Assign FPC of the final destination node
in this parameter.
FUSION POINT
CODE (FPC)
1-253
9
CONNECTION ROUTE
FCCH NUMBER/FUSION
POINT CODE NUMBER
(FCHN/FPCN) 1-255/1-253
C_RT
The Connection Route
(B-channel)
Note 1: "USE_GATE" data is automatically set and this parameter won't appear on the MAT display since
Release 8 software enhancement. This data assignment is required of Release 7 or earlier software only.
Note 2: It depends on the assignment on P_ROUTE parameter, whether the direct connection or FCH connec-
tion routing is selected.
In redundant configuration of internal LAN, #A/#B system changeover is to be activated in case all the
routes, both for direct connection and FCH connection, are unable to communicate.
According to the P_ROUTE assignment, the route is selected in the following order;
When "0=FCCH" is selected,
#A direct connection → FCH #A → #B direct connection → FCH #B
or
#B direct connection → FCH #B → #A direct connection → FCH #A
When "1=FGH" is selected,
FCH #A → #A direct connection → FCH #B → #B direct connection
or
FCH #B → #B direct connection → FCH #A → #A direct connection
FPC
FCCH USE OR
NOT USE (FCCH)
0/1
1
CNT
(C_RT)
1-1023
FCHN/FPCN
If "FCCH=0 (FCH card is not used.),
assign Fusion Point Code Number of the final
destination node.
If "FCCH=1 (FCH card is used.),
assign the FCCH number
FCCH
0=The FCH card is not used
1=The FCH card is used
GATEWAY FUNCTION
USE (USE_GATE)
0/1
2 3
1
10 10 10
11 11 11
ND-70348 (E)
USE_GATE
0=Gateway Function is not used
1=Gateway Function is used
Note 1
PRIORITY ROUTE
(P_ROUTE)
0/1
7
4 5 6
10 10 10 10
11 11 11 11
AFPC
P_ROUTE
0=FCCH
1=FGH
Note 2
8
10
11
CHAPTER 4
Page 634
Revision 3.0