Aaed: Assignment Of Announcement Equipment Data - NEC NEAX 7400 IMX Command Manual

AAED: Assignment of Announcement Equipment Data

1. General
This command is used to assign the trunk information related to Announcement Equipment on a tenant basis.
For the Hotel system, it is also possible to assign Language Class when Language Service of PMS (Property
Management System) is provided.
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX 93, bit7=1), assign TN pa-
rameter as data "1" for all tenants.
2. EQP parameter designates the kind of service feature provided by the announcement trunk.
In the Hotel system, the relationship between the EQP number and the kind of service feature can be ar-
ranged by the AHSY command.
3. Parameter LANG is appeared in the Hotel system provided "Language Service" (SYS1, INDEX 161, b2 =
1 in the ASYD command.)
4. The data "0 (Common)"of LANG parameter means that the guest will listen the "Common" message from
the announcement equipment if the guest does not registered the language information through PMS.
5. The R parameter specifies whether the Ring Back Tone (RBT) is provided prior to sending the message or
not.
6. When a trunk incoming call is connected to the announcement, whether the answer signal is sent out or not
is specified by the A parameter.
7. When data "0 (Single connection)" is assigned in the M parameter, the trunk number assignment (TK) may
not be required. The alternative trunk routing within a route is automatically executed.
8. The route number (RT) and trunk number (TK) of the announcement trunk are assigned by the ATRK com-
mand.
ND-70348 (E)
AAED
CHAPTER 4
Page 477
Revision 5.0