Acddl: Assignment Of Change Digit Code For Dial In Service For Ldm - NEC NEAX 7400 IMX Command Manual

ACDDL: Assignment of Change Digit Code for Dial In Service for LDM

1. General
This command is used to assign the Change Digit Code for the ISDN line with DID Addressing. This data is
written in the Local Data Memory (LDM).
2. Precautions
1. This command does not affect if DC=0 (Sub Address - Addressing) is assigned by the ARTD command.
2. Enter the Logical Route Number of the B-channel route in the parameter "LGRT."
3. This command is available since Release 11 software enhancement.
3. Data Entry Instructions
D/N
D = Day Mode
N = Night Mode
LOGICAL
DAY/
DIGIT CODE
ROUTE
NIGHT
NUMBER
MODE
MAX. 7 DIGITS
(LGRT)
(D/N)
[0-9, *, #]
1-899
LGRT
When ISDN line is used, enter the Logical
Route Number of the B-channel route.
DC
Number of digit for this DC
must match the data in DC of
the ARTD command.
(DC)
Always select "Out of Service" in AD parameter when ISDN DID Addressing.
• Out of Service = Additional Dialing Service is invalid
• In Service = PBX dial-in Additional Dialing Service (Japan) is valid
Always select "In Service" in XFR parameter
when ISDN DID Addressing is provided.
• In Service = Transfer is valid
• Out of Service = Transfer is invalid
CHANGE DIGIT CODE
(CDC)
MAX.24 DIGITS
[0-9, *, #, P]
ND-70348 (E)
XFR
ADDITIONAL
DIALING
(AD)
AD
CHAPTER 4
Revision 5.0
ACDDL
TRANSFER
SERVICE
(XER)
Page 602