Command Description Data Sheet - NEC NEAX 7400 IMX Command Manual

CHAPTER 4 COMMAND DESCRIPTION AND DATA SHEET
This chapter explains command parameters of the system, and the data sheet is given for each command. Since the
commands are listed in standard programming order illustrated in Chapter 2 Section 5 Data Assignment Flow Chart.
If you know a command name, and you want quick access to the command's description, you can refer to "Com-
mand List in Alphanumeric Order," on page ix to find the page on which the command is described.
The contents of each command description are illustrated in "Figure 4-1 Command Descriptions" on the next page.
The data sheet is prepared on the page next to the command description.
Note 1: Data for the most frequently used parameters are as follows.
TN = 1-63
STN = Maximum 5 digits
LENS = 6 digits (Module Group, Unit, Group, Level)
MG = 00~01 for 1IMG System/00~07 for 4IMG, 16IMG System
RT = 1-255 (maximum number of route is designated by the ASYD command, INDEX 65.)
TK = 1-255
Attendant Consoles = 1-16 for 1IMG System/1-32 for 4IMG System/1-60 for 16IMG System
The following functions have been established since Release 8 software enhancement;
Note 2:
1. It is possible to readout/list-up the existing NDM data without logging in to the NCN (Network Control
Node) in Netfusing system. When assigning the NDM data, NCN log-in is required as before.
2. The new commands for concealing physical station number (with "_T" in the command name), have
the function to assign the station data by using Telephone Number instead of Physical Station Number.
These new commands execute the data assignment/deletion for the DM (Data Memory) only, as the
same as the existing command.
COMMAND DESCRIPTION AND DATA SHEET
ND-70348 (E) CHAPTER 4
Page 70
Revision 3.0