Adai: Assignment Of Terminal Application Data - NEC NEAX 7400 IMX Command Manual

ADAI: Assignment of Terminal Application Data

1. General
This command is used to assign/delete application data for terminals.
2. Precautions
This command is available for Australia only.
3. Data Entry Instructions
a.) When MODE=1 (Station) is assigned:
Enter the Station Number to which this application
service is applied when "MODE=1" is set.
MODE
Assign "1".
1 = Station
2 = Trunk
3 = LENS
TENANT
MODE NUMBER
1-3 (TN)
1
TN
Assign the Tenant Number to which
this application service is applied
when "MODE=1" is set.
page 569
See
Note:
STN
USPEED
Assign the User Rate, based on the LLC
(Low Layer Compatibility) information
element (TTC Q931) within the range
from 0~31.
USER
STATION
SPEED
NUMBER
(USPEED)
(STN)
0-31
Max. 6 Digits
Test Circuit Card
0/1 = Not exist/Exist
for other parameters.
Assign Intermediate Rate, based on
the LLC information element within
the range from 0-3.
TEST LINE HOT LINE
CIRCUIT (HL)
(TLC) 0/1
0/1
TLC
Hot Line Recognition
0 = -
1 = Use Hot Line
ND-70348 (E)
IRA
0 = Not assigned
1 = 8kbps
2 = 16kbps
3 = 32kbps
INTERMEDIATE ALARM
RATE
(IRA)
0-3
HL ALM
0 = -
1 = Alarm
CHAPTER 4
Revision 3.0
ADAI
(ALM)
0/1
Page 566