Asat: Assignment Of Specific Attendant Number Data - NEC NEAX 7400 IMX Command Manual

ASAT: Assignment of Specific Attendant Number Data
1. General
This command is used to assign a specific Attendant Number which allows a station user to access the desired
operator.
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX 92, bit3=1), assign TN pa-
rameter as data "1" for all tenants.
2. The specific attendant number cannot be a station number or LDN already being utilized.
3. The maximum number of Attendant Consoles should be assigned by the ASYD command, SYS 1, INDEX
9.
3. Data Entry Instructions
TN
Enter the tenant number which
affects the special attendant number
TENANT NUMBER
(TN)
1
Enter the ATN which corresponding to the TK parameter assigned by the ATRK command
Enter the special attendant number
according to the station numbering plan.
ACCESS CODE (ACC)
MAXIMUM 5 DIGITS
6 0 0 1
ATN
ND-70348 (E)
ACC
ATTENDANT NUMBER
(ATN)
1
ASAT
REMARKS
CHAPTER 4
Page 464
Revision 3.0