6.
If the station user accepts the default settings, the data assignment of this command is not required. The
default data for each line/feature button is shown below.
KEY NO.
1
CALL PICKUP
2
CALL FORWARDING - BUSY LINE
CALL FORWARDING - ALL CALLS
3
CALL FORWARDING - DON'T ANSWER
4
EXECUTIVE RIGHT OF WAY
5
VOICE CALL
6
MESSAGE REMINDER
7
SAVE AND REPEAT
8
LAST NUMBER CALL
7.
The ability to assign Sub Line appearances across module groups is available when ASYD command
SYS1, INDEX321, bit0 = 1 is assigned. Stations can appear on D
module group within the same IMG.
8.
When assigning the line/feature buttons as function keys, take the following precautions:
(a) My Line key must be programmed.
(b) Not used line/feature buttons should be assigned as KYI = 0 (Not used)
(c) The following function keys are basically fixed:
FKY = 13:CONF (Three - Way Calling)
FKY = 18:TRANSFER (Call Transfer-All Calls)
FKY = 20:HOLD (Non - Exclusive Hold/ Exclusive Hold)
FKY = 28:ANSWER
FKY = 51:MIC
FKY = 52:SPEAKER
FKY = 57:RECALL
9.
The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
Table 4-11 Default Data for Each Line/Feature Button
DEFAULT DATA
ND-70348 (E)
KEY NO.
DEFAULT DATA
9
PRIME LINE
10
SPEED CALLING ONE-TOUCH
SPEED CALLING ONE-TOUCH
11
12
SPEED CALLING ONE-TOUCH
13
SPEED CALLING ONE-TOUCH
14
SPEED CALLING ONE-TOUCH
15
SPEED CALLING ONE-TOUCH
16
SPEED CALLING - SYSTEM
term
which accommodated the different
AKYD
CHAPTER 4
Page 338
Revision 3.0