Configuring Imx Mat; Serial/Direct Connection; Pbx Administration Default Values - NEC NEAX 7400 IMX Command Manual

6. Configuring IMX MAT

This section explains the PBX Alias parameters you may configure using the PBX Administration dialog window.
It also lists the default values of NEAX-IMX, the default PBX Alias delivered with the IMX MAT software. Prior
to running the IMX MAT, you should either define a new PBX Alias, configure the default PBX to work with your
system, or plan to use the NEAX-IMX default Alias. NEAX-IMX is ready for use once the IMX MAT software has
been successfully installed. Table 2-3 lists the default values displayed in the PBX Administration dialog box when
you select NEAX-IMX as your PBX Alias.

6.1 Serial/Direct Connection

The following steps explain how to configure the PBX Alias for a serial/direct connection using the recommended
default data.
Note: You can use other data when configuring IMX MAT. However, it is recommended that you use the default
data as previously described when configuring a new PBX Alias.
Table 2-3 PBX Administration Default Values
PBX Alias
Connection Type
FPC
Connect
Response Timeout
Pacing Timer
Link Data Log Path
COM Port
Baud Rate
Ignore CTR
Ignore DSR
Modem Name
Phone Number
Host Name
IP Address
TCP Port
Inter-App Resource
ND-70348 (E)
NEAX-IMX
Serial/Direct
1
120000
120000
10000
blank
COM 1
4800
blank
blank
blank
blank
blank
172.16.253.0
60000
blank
HOW TO OPERATE MAT
CHAPTER 2
Page 32
Revision 3.0