NEC NEAX 7400 IMX Command Manual page 556

3. Data Entry Instructions
UGN is fixed to "1".
Enter the TELN (NDM) of the UCD pilot station with respect to the data assigned by the ASHUN
command.
Enter the delay timer value in second with a range of 0-
30 seconds. (2 seconds increments)
CONTROLLING
STATION
USER TELE-
GROUP PHONE
NUMBER NUMBER
(UGN) (TELN)
Announcement replay
0 = Once
1 = Repeat within the time specified by the INT parameter
The INT parameter is appeared when RP = 1.
Enter the replay interval time value in seconds with a range
of 0-30 seconds. (2 seconds increments)
74.
UGN and TELN
DLYT
Enter the message timer value in seconds within 0-30 seconds.
(2 seconds increments)
However, this value is not effective if the Route data of Announcement
Trunk is assigned as follows:
MESSAGE ANNOUNCE-
DELAY
TIMER
TIMER
(MSGT) OUTPUT
(DLYT)
0-30 REPLAY
0-30
RP
INT
ARTDN ANS=1
REPLAY NUMBER OF
MENT INTERVAL ANNOUNCEMENT
(INT)
0-30
(RP)
0/1
The number of external trunks to be
connected to an external
announcement machine.
Enter the Logical Route Number of the Announcement
Trunk. (Announcement Trunk should be mounted on the
same node in which the UCD pilot station is
accommodated.
ND-70348 (E)
MSGT
ANNOUNCEMENT
TRUNK
TRUNK
LOGICAL
(CNT)
ROUTE
1-8
NUMBER
(LGRT)
1
2
CNT
LGRT
AUADN
TRUNK
NUMBER
(TK)
CHAPTER 4
Page 539
Revision 3.0