Aspan: Assignment Of Special Access Code For Ndm - NEC NEAX 7400 IMX Command Manual

ASPAN: Assignment of Special Access Code for NDM

1. General
This command is used to assign the numbering plan data of the Network Control Node (NCN). The data as-
signed on this command is written in the Network Data Memory (NDM) of the Network Control Node (NCN),
updating the NDM at each Local Node (LN).
2. Precautions
1. This command is used for the Business/Hotel (for Admin. station only) Application.
2. The applicable tenant number (TN) range is designated by the ASYDN command, SYS 1, INDEX 8. If the
numbering plan is common for all tenants (ASYDN, SYS1, INDEX 800, bit1 = 1), assign TN parameter
as "1" for all tenants.
3. For more detail, see the "Netfusing System Manual".
3. Data Entry Instructions
TENANT ACCESS CODE
NUMBER (ACC)
(TN) MAX. 6 DIGITS
ACC
Access code (Max. 6 digits)
CI
N=Normal service
H=Hooking service
B=Busy service
When SRV= SSC (Service code) is assigned;
SERVICE INDEX
(SID) 1-63
SID
See Table 4-30 (Next Page)
FPC appears when the following SID is entered.
SID
2 (Dial Access to Attendant: Operator Call)
37 Priority Call 1
38 Priority Call 2
39 Priority Call 3
CONNECTION STATUS
SERVICE (SRV)
INDEX
(CI) N/H/B
SSC=Service code
OGC=Outgoing call
LCR=Least cost routing
ANNC=Announcement Service
PAGA=Paging Answer
TELN=Telephone Number
FUSION POINT CODE
(FPC)
FPC
Number of FPC
1-253
1-253
1-253
1-253
KIND OF
SRV
SSCA=Service code appendix
OGCA=Outgoing call with route advance
LCRS=Register sender LCR
ANNCM=Announcement Service (Multiple Announcement)
PAGC=Paging Cancel
ND-70348 (E)
ASPAN
CHAPTER 4
Page 677
Revision 3.0