Acfr: Assignment Of Call Forwarding Restriction - NEC NEAX 7400 IMX Command Manual

ACFR: Assignment of Call Forwarding Restriction

1. General
This command is used to assign various kinds of trunk call forwarding restriction data on a tenant basis.
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
If data of this command is common for all tenants (ASYD command, SYS1, INDEX92, bit5=1), assign TN
parameter as data "1" for all tenants.
3. Data Entry Instructions
1 = Call Forwarding (-All Calls/-Don't Answer/
-Busy Line/Unused Number/Dead Level)
2 = Direct in Termination(Night only)
3 = Direct in Termination(Day and Night)
4 = Direct Inward Dialing(DID)
5 = TAS
7 = Remote Access to System
8-14 = Not used
15 = CAS Line connection(Satellite)
TRANSFER
TENANT
SERVICE
NUMBER
(TN) FEATURE
INDEX
(TSFI) 1-15
1 1
2
3
4
5
TSFI
6 = Night ATT
0 1 2 3
RESTRICTION DATA(RES) is assigned in the squares where CCI
and TSFI cross.
0=Transfer service is restricted.
1=Transfer service is allowed.
0 =Attendant Call
2 = DDD2
4 = Tie Line
6 = Recall
7 = Call Forwarding-Busy Line
8 = Call Forwarding-Don't Answer
9 = Not used
10 = Special common Battery
11 = Inter Position Transfer
12 = Priority call
13 = Off Hook Alarm
15 = Not used
CALL CATEGORY INDEX (CCI) 0-15
4 5 6 7 8
RES
ND-70348 (E)
CCI
1 = LDN (C.O. Line)
3 = DDD3
5 = DDD4
14 = CAS (Main)
9 10 11 12 13 14
ACFR
15
CHAPTER 4
Page 315
Revision 3.0