NEC NEAX 7400 IMX Command Manual page 366

5. The LCD display will not be changed for a minute, after the soft key data is assigned via this command or
the characters for the LCD display is changed via the AFDD command.
6. When the soft key data is programmed for the busy station, the LCD display will not be changed until the
station is becomes idle.
7. After the system initial is performed, the soft key can not be used for a minute.
8. SKP=0 in this command is assigned for the key pattern to be used commonly in a system (Available since
Release 5).
9. The priority order to display the data in the function key area (third line or the lowest line) is as follows.
Priority
order
1
2
3
Note
(a)
4
Note (b)
(c)
Soft key data assigned by the user may be changed to the other soft key data in lower priority via page
Note:
change key.
10. The same function data can not be assigned to both soft key and function key.
11. The created soft key pattern, which is assigned at SKP≠0, is applied to a D
grammed SKP number in ADKS. As for the key pattern data in SKP=0, ADKS is not necessary. If SKP=0
is designated in ADKS, default key pattern data (refer to Table 4-18
Displayed Data
Services set to the
function key data
Services set to the
function key data
Soft key assigned
via each station
Soft key data used
on a station basis
Soft key used
on a system basis
Default soft key data
by ROM data
The application service which is set to the function key
Only when the station is idle/originating and the service set to
the function key
The soft key data which is in the middle of being set via the
function key (FKY=122).
The soft key data to be assigned by the ADSL (SKP≠0) and
ADKS command.
The soft key data to be assigned by the ADSL (SKP=0).
Default soft key data when (a) or (b) shown above is not
assigned.
ND-70348 (E)
Description
term
75 by designating the pro-
(page 364)
) is applied to a D
ADSL
term
.
CHAPTER 4
Page 361
Revision 3.0