Asdt: Assignment Of Station Data - NEC NEAX 7400 IMX Command Manual

ASDT: Assignment of Station Data

1. General
This command is used to assign/delete the physical station data.
2. Precautions
1. This command is used for Business application. The AAST/AGST commands are used for Hotel applica-
tion.
2. The ASTN command may be used to change the station number.
3. The ASCL command may be used to change the Class (TEC, RSC, and/or SFC) of the station.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
5. The number of station number (STN) digits is designated by the ASYD command, SYS1, INDEX16.
6. The first digit of the station number (STN) is designated by the ANPD command.
7. The RSC and SFC parameter works conjunction with ARSC and ASFC command respectively.
8. TEC 3 (DP/PB) is to be used in the installation test only. Give the proper TEC to each station before ser-
vice-in.
If the PB (DTMF) station given TEC 3 tries to make a call to the PB (DTMF) route with the 2nd DT mode,
Note:
the call will not be successful.
9. An example of the LENS allocation is shown in Figure 4-2 on the next page.
10. LSDT (Listup of Station Data) command is used to print out the station data. At this time, ETN (Executive
Tenant Number) data is also printed out.
While some commands share the common TN in office data, others develop separate TN table respectively.
In case of adapting common TN for all the commands, the TN actually assigned by the ASDT command
is to be executed.
ND-70348 (E)
ASDT
CHAPTER 4
Page 319
Revision 3.0