Afrsn: Assignment Of Flexible Route Selection Data For Ndm - NEC NEAX 7400 IMX Command Manual

AFRSN: Assignment of Flexible Route Selection Data for NDM

1. General
This command is used to assign the area and/or office code data for the OPR assigned by the AOPRN command.
The data assigned by this command is written in the Network Data Memory (NDM) of the Network Control
Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYDN command, SYS1, INDEX8. If data
of this command is common for all tenants (ASYDN command, SYS1, INDEX800, bit4=1), assign TN pa-
rameter as data "1" for all tenants.
2. After an Outgoing Route Selection Pattern Number (OPR) has been assigned in this command, it is neces-
sary to assign the LCR routing pattern/six (6) digits routing pattern by the AOPRN/ASDC command re-
spectively.
3. It should be noted that the access code may or may not be included in the Number Pattern Code (NPC)
depending upon the assignment of AC parameter by the ARTDN command. If zero (0) is assigned, the ac-
cess code is not included. If one (1) is assigned, the access code must be included.
4. Assign the dummy route number in the LGRT parameter.
5. When assigning such a number as shown below to parameter "NPC", enter "T" code to the end digit of
"NPC."
Example:
When assigning 90 and 900 to NPC:
Number
90
900
Input Number for NPC
90T
900
OPR
X
Y
ND-70348 (E)
AFRSN
CHAPTER 4
Page 263
Revision 3.0