Aslu2: Assignment Of Slumber Time Data 2 - NEC NEAX 7400 IMX Command Manual

ASLU2: Assignment of Slumber Time Data 2

1. General
This command is used to assign the data related to the Slumber Time - Do Not Disturb service feature.
2. Precautions
1. The slumber time period and the forwarded destination are assigned by this command. A maximum of four
(4) different time periods can be assigned as the Slumber Time.
2. The G parameter corresponds to the one assigned by the ASLU1 command. The station numbers belonging
to the slumber group are assigned by ASLU1 command.
3. Denial of the Slumber Time - Do Not Disturb service feature can be assigned by the following commands:
(a) ARTD command, SLOV=1 is assigned for trunk route
or
(b) ASFC command SFI=107, RES=1 is assigned for the class of the originating station.
4. The AAED command should also be assigned if TFR=2 (DAT card) is assigned.
5. Time data should be assigned as 24 hours a day (military time).
6. When making multiple time data assignments for a specific Slumber Time Group, the time data assigned
must not be duplicated.
7. If the slumber service is required 24 hours a day, enter the same time data into the both parameters, FROM
HOUR/FROM MINUTE and TO HOUR/TO MINUTE.
ND-70348 (E)
ASLU2
CHAPTER 4
Page 564
Revision 3.0