Acfs_T: Assignment Of Call Forwarding Station Data – Tel. Number - NEC NEAX 7400 IMX Command Manual

ACFS_T: Assignment of Call Forwarding Station Data – Telephone Number
1. General
This command is used to set the Call Forwarding - All Calls/Busy Line/Don't Answer, and further the Split Call
Forwarding Services for each station. The station data of ACFS command can be assigned by using Telephone
Number instead.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
3. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
4. The "RCV" parameter can be assigned when ASYD, SYS1, INDEX79, b2=1 (Split Call Forwarding is In
Service), and "Split Call Forwarding" is selected in "TYPE" parameter.
5. This command is available since Release 8 software enhancement.
3. Data Entry Instruction
TELN
Enter the Telephone Number of the station
to which this service is to be assigned.
TELEPHONE NUMBER
UGN
Max. 16 digits
TYPE
Select the type of Call Forwarding.
Call Forwarding
Split Call Forwarding
When "Type = Split Call Forwarding" is
entered, select the kind of received call.
The existing data is readout by pressing "Get" button after UGN and TELN is entered.
Note:
FORWARDING
(TELN)
RCV
Trunk
Telephone Number
Enter the call forwarding destination
number within 24 digits.
CALL KIND OF
RECEIVED FORWARDING
TYPE CALL
(TYPE) (RCV)
Select the kind of Call Forwarding.
• PS Incoming Incomplete
ND-70348 (E)
CFD
CALL FORWARDING
CALL
DESTINATION
NUMBER
KIND
(CFD)
(SRV)
Max. 24 digits
SRV
All Calls
Busy Line
Don't Answer
ACFS_T
CHAPTER 4
Page 560
Revision 3.0