Apipl: Assignment Of Ip Address Data For Point Code For Ldm - NEC NEAX 7400 IMX Command Manual

APIPL: Assignment of IP Address Data for Point Code for LDM

1. General
This command is used to assign, delete, and readout the IP address data to the Point Code (PC) of the destination
node. This data is written in the Local Data Memory (LDM).
2. Precautions
1. This command is available for the software Release 9 or later.
3. Data Entry Instructions
Enter the Point Code of Destination Node.
DESTINATION
POINT CODE
(PC)
1-16367
CNT
CNT=2-8 is not used now.
PC
COUNT
NO.
IP ADDRESS
(CNT)
1-8
1
2
IP ADDRESS
Enter the IP address of the IPTRK card
in the Destination Node.
Select the either radio button.
• Permanent Virtual Connection
Keep TCP Connection permanently.
• Switched Virtual Connection
Disconnect TCP Connection when firmware does not find a
message on TCP transmitted/received in a fixed time set by
timer. (an ordinary mode)
MODE
ND-70348 (E)
MODE
TIMER
REMARKS
0-127
TIMER
Used in Switched Virtual Connection.
Set the time passed until disconnecting TCP
Connection.
0: 15 minutes (default setting)
1-127: 1-127 minutes
APIPL
CHAPTER 4
Page 271
Revision 5.0