NEC NEAX 7400 IMX Command Manual page 443

CONTENTS/INPUT
0-Detailed billing is not required for incoming calls.
b0
1-Detailed billing is required for incoming calls.
0-Detailed billing is required for toll and local outgo-
ing calls.
b1
1-Detailed billing is required only for toll outgoing
calls.
0-
1-Metering pulses are used.
b2, 3
2-
3-
LOGICAL ROUTE (LGRT) 1-899
FUSION POINT CODE (FPC) 1-253
ROUTE NUMBER (RT) 1-255
0 =
24 OC
1 = Originating Category Information is used
Attendant-Identification of Incoming Trunk Display.
25 R/L 0 = TN, RT, TK display
1 = C.O. Line Number display
Trunk Reversal Identification
This data is necessary when a specific Trunk route provides
26 RVSD battery reversal for answer supervision.
0 = Battery Reversal System
1 = Third Wire System
27 TL Tone Level
Answer signal from Trunk side.
28 ANS 0 = No answer signal is given.
1 = Answer signal is given.
Time Elapse Indication Service
29 TELP
0 = Out of Service
This data determines Pad control on the ODT/DTI circuit
card.
30 PAD TLT (EMT)
0 = Depending on setting.
7 = Pad Off(0db)
Table 4-24 SMDR2 (ALRNN)
-
ND-70348 (E)
0 1 2 3 4 5 6
× × × ×
× × ×
× × × ×
× × × ×
× × × ×
1 = In Service
DTI
–
Pad Off(0db)
7 8 9 10 11 12 13 14 15
×
REMARKS
For MFC signaling
(Brazil and Mexico)
0 0 0 0 Always assign data "0."
Time Elapse Indication
(TELP) is a warning tone
sent to the caller after a
predetermined period of
time has elapsed (usually
three minutes).
Pad=1-6: Actual PAD
value depends on PAD
ROM on the ODT/DTI
circuit card. (See Circuit
Card Manual.)
ALRNN
CHAPTER 4
Page 436
Revision 3.0