Adim: Assignment Of Dial Intercom Data - NEC NEAX 7400 IMX Command Manual

ADIM: Assignment of Dial Intercom Data

1. General
This command is used to assign Dial Intercom service related data.
2. Precautions
1. For providing Dial Intercom Service, it is necessary to assign the following data in advance:
ASYD command, SYS1, Index 59, b7 = 1
2. The number of D
digits for Call Number (Dial Intercom STN) are determined by parameter N (Dial Intercom Digit Number).
3. When N= 0 is entered, a maximum of 10 Intercom Station Numbers can be assigned.
When N=1 is entered, a maximum of 64 Intercom Station Numbers can be assigned.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
5. Enter "My Line" Station Number of D
6. Compose a Dial Intercom Group with D
(Module Group).
7. From 1 to 50 Dial Intercom Groups can be composed on each MG (Module Group) basis.
8. An Intercom member can override another Intercom station in a two-party Intercom connection. This kind
of overriding is referred to as INTERCOM BRIDGE.
3. Data Entry Instructions
MODULE GROUP
GROUP
NUMBER NUMBER
(MG No.) (G-ID)
1-50
ICMCT INTERCOM STATION
NUMBER (ICM STN)
0
1
term
stations that can be accommodated in a Dial Intercom Group and also the number of
term
N
0=one digit (0-9)
1=two digits(00-63)
DIAL INTERCOM
ID DIGIT
NUMBER
(N)
0/1
ICMCT
in the "ICMSTN" (Dial Intercom Station Number) parameter.
term
stations of the same TN (Tenant Number) under the same MG
BCR
0=Restricted
1=Allowed
BRIDGE
CALL
RESTRIC-
TION(BCR)
0/1
INTERCOM STATION
NUMBER (ICM STN)
5
6
ND-70348 (E)
TENANT
NUMBER
REMARKS
(TN)
REMARKS
ADIM
CHAPTER 4
Page 374
Revision 3.0