Acnan: Assignment Of Calling Number Pattern Data Per Access Code (Ndm) - NEC NEAX 7400 IMX Command Manual

ACNAN: Assignment of Calling Number Pattern Data per Access Code (NDM)

1. General
This command is used to assign the Calling Number Pattern (CNP) on an access code basis. CNP is used for the
SID to Network-Present service and for the Calling Party Recognition service. The data assigned by this com-
mand is written in Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at
each Local Node (LN).
2. Precautions
1. The CNP parameter in this command corresponds to the one assigned by the ACNDN command.
2. This command is available since Release 10 software enhancement.
3. Data Entry Instructions
Assign an access code for
specifying the destination.
LOGICAL
INCOMING
ROUTE
OR
NUMBER
OUTGOING
(LGRT)
(IC/OG)
1-899
IC
OG
ACC
ACCESS CODE
(ACC)
MAX. 16 DIGITS [0-9, *, #]
Assign the number of digits for specifying called station number
(used for Direct Inward Dialing-in (DID) Addressing). This data
setting has precedence over that of CDN66 (DC) -ARTD
/ARTDN command. (This parameter is required for "IC".)
Further data assignment by using the ACNDN command
is required. (This parameter is required for "OG".)
CALLING
NUMBER
PATTERN
(CNP)
1-1023
DC
ND-70348 (E)
CNP
DIALED NUMBER
REMARKS
CONFIRMATION
(DC)
1-7
Revision 4.0
ACNAN
CHAPTER 4
Page 604-2