Aipdl: Assignment Of Ip Service Pad Data For Ldm - NEC NEAX 7400 IMX Command Manual

AIPDL: Assignment of IP Service PAD Data for LDM

1. General
This command is used to assign and delete the PAD data for IP service. It can also be used for reading out the
already assigned data to modify it. This data is written in the Local Data Memory (LDM).
2. Precautions
1. This command is valid when IPTRK service software is programmed.
2. PAD data of IP Trunk card can be assigned per Node as the pattern shown in the table below;
IC TERMINAL
Trunk
Analog Telephone/Dterm
ISDN Terminal
Connection Trunk
IPELC
IPTRK
3. If both "NODE" and "IPG" data for IC/OG Terminal parameter are restricted, this command cannot be
used.
4. This command is available for the software Release 9 or later.
5. "IPG" parameter is available since Release 10 software enhancement.
OG TERMINAL
IPTRK
IPELC
Trunk
Analog Telephone/Dterm
ISDN Terminal
Connection Trunk
IPTRK
IPELC
Trunk
Analog Telephone/Dterm
ISDN Terminal
Connection Trunk
ND-70348 (E)
X: PAD data can be flexibly assigned by this command.
IC PAD OG PAD
X
PAD OFF
PAD OFF
X
X
X
X
X PAD OFF
X PAD OFF
X
X
X
X
X PAD OFF
X PAD OFF
X
AIPDL
DATA
X RT-Node
X Node-SFC
X Node-SFC
X C_RT-Node
X IPG-Node
X IPG-IPG
X IPG-RT
IPG-SFC
IPG-SFC
X IPG-C_RT
X Node-Node
X Node-IPG
X Node-RT
Node-SFC
Node-SFC
X Node-C_RT
CHAPTER 4
Page 645
Revision 5.0