NEC NEAX 7400 IMX Command Manual page 515

CDN
TRUNK DATA
18 TS When assigning this data, zero (0) should al-
ways be entered.
19 CDCSPD When assigning this data, zero (0) should al-
ways be entered.
20 DVRST Call restriction while Tie Line is backed up on
ISDN.
0 = No restriction
1 = Speech call restriction (Speech. 3.1 kHz
audio, 7 kHz audio calls are restricted)
2 = Data call restriction (Unrestricted digital,
restricted digital and Video data are re-
stricted.)
3 = Both Speech and Data calls are restricted.
21 RSCT Call restricted by Temporary Route Informa-
Note 1
tion
0 = No restriction
Note 1:
PRT = 1.
22 ROCG Outgoing Call Account by Temporary Route
Information
0 = Not used
Note 2:
TMPRT = 1.
23 RICG Incoming Call Account by Temporary Route
Information
0 = Not used
Note 3:
TMPRT = 1.
24 STSENQ Status Inquiry Message Send
0 = Out of service
25 MMNPASS When assigning this data, zero (0) should al-
ways be entered.
26 DLTK (Japan only)
When assigning this data, zero (0) should al-
ways be entered.
27 CALN (Japan only)
When assigning this data, zero (0) should al-
ways be entered.
28 NETINT (Japan only)
When assigning this data, zero (0) should al-
ways be entered.
29 INBAND When assigning this data, zero (0) should al-
ways be entered.
ROUTE NUMBER
1 = Restriction
This data is effective when TM-
Note 2
1 = Effective
This data is effective when
Note 3
1 = Effective
This data is effective when
1 = In service
ND-70348 (E)
0 0
0 0
0 0
0 0
0 0
0 0
0 0
ARTI
0 0
0 0
0 0
0 0
0 0
0 0
0 0
CHAPTER 4
Page 501
Revision 3.0