NEC NEAX 7400 IMX Command Manual page 356

9. A virtual line can be assigned as a Sub Line of the D
My Line for outgoing calls and other service operations.
Note: Virtual Line --- A virtual LENS exists only in memory, but does not exist physically. Data can be assigned
but no hardware is required.
Example: LENS = 000311. The virtual LENS is assigned by the ASDT command in the same way as an ordinary
line. (The telephone class is TEC = 18: Virtual Line)
10. If the station user accepts the default settings, the data assignment of this command is not required. The
default data for each line/feature button is shown below.
KEY
NO.
1 CALL PICKUP
2 CALL FORWARDING - BUSY LINE
CALL FORWARDING - ALL CALLS
3
CALL FORWARDING - DON'T ANSWER
4 EXECUTIVE RIGHT OF WAY
5 VOICE CALL
6 MESSAGE REMINDER
7 SAVE AND REPEAT
8 LAST NUMBER CALL
11. The ability to assign Sub Line appearances across module groups is available when ASYD command
SYS1, INDEX321, bit0 = 1 is assigned. Stations can appear on D
module group within the same IMG.
12. When assigning the line/feature buttons as function keys, take the following precautions:
(a) My Line key must be programmed.
(b) Not used line/feature buttons should be assigned as KYI = 0 (Not used)
(c) The following function keys are basically fixed:
FKY = 13: CONF (Three - Way Calling)
FKY = 18: TRANSFER (Call Transfer - All Calls)
FKY = 20: HOLD (Non - Exclusive Hold/Exclusive Hold)
FKY = 28: ANSWER
FKY = 51: MIC
FKY = 52: SPEAKER
FKY = 57: RECALL
Table 4-15 Default Data for Each Line/Feature Button
DEFAULT DATA
ND-70348 (E)
term
. The virtual line can be used the same way as the
Note
KEY
DEFAULT DATA
NO.
9 PRIME LINE
10 SPEED CALLING ONE-TOUCH
11 SPEED CALLING ONE-TOUCH
12 SPEED CALLING ONE-TOUCH
13 SPEED CALLING ONE-TOUCH
14 SPEED CALLING ONE-TOUCH
15 SPEED CALLING ONE-TOUCH
16 SPEED CALLING - SYSTEM
term
which accommodated the different
AKYD_T
CHAPTER 4
Page 351
Revision 3.0