NEC NEAX 7400 IMX Command Manual page 807

When SRV=UNIF (Office termination) is assigned:
Note:
This data is available for ACIS only. For CCIS, use the AUNE command.
When SRV=ANNC (Announcement service-Single announcement) is assigned;
When SRV=ANNCM (Announcement service-Multiple announcement) is assigned;
TENANT NUMBER
When SRV=TELN (Telephone Number)
Note: Note that this Telephone Number is available to make a call and receive a call within the self node only.
If the Telephone Number is to be used within the Netfusing Network, assign it at Network Control Node
(NCN) by using the ASPAN command.
ANNOUNCEMENT EQUIPMENT NUMBER
(EQP) 0-127
Assign the announce equipment number.
EQP3 and 5-14 can be used for SRV=ANNC (Single announcement).
ANNOUNCEMENT EQUIPMENT NUMBER
(TN) 1-255
TN
Assign the tenant number of
the announcement trunk.
NECESSARY DIGIT
(NND) 1-16
SKIP DIGITS
(SKIP) 0-5
SKIP
Assign the skip digits to terminate the call.
EQP
(EQP) 122-125
Assign the announcement equipment number
range from 122 to 125 (Multi announcement).
ND-70348 (E)
AGSPL
EQP
CHAPTER 4
Page 766
Revision 3.0