NEC NEAX 7400 IMX Command Manual page 282

3. Data Entry Instructions
KIND
PFX=PFX (Prefix)
SCC=SCC (MCI, SPRINT)
Enter the OPR assigned
by the AFRS command
KIND OF TIME OF DAY
SELECTION CHANGE
(KIND) PATTERN
NUMBER
(TDPTN) 0-7
Enter data "1-7" if TDPTN/PTN is assigned by the ATCP/ACMO
command, otherwise "0".
single OPR.
Enter RA as the route advancing order
OPR
SELECTION
PATTERN ADVANCING
NUMBER
(OPR)
0-4000
TDPTN
Different TDPTN data can be assigned to a
Enter the data (EFFECT) in the space of the corresponding office code. Note that
the meaning of data varies depending on the KIND parameter.
• When parameter KIND is assigned as PFX:
0=an additional digit is not required.
1=the digit "1" is required as prefix for access to an FX line.
2=the digit "1" is required as prefix for access to an FX line (display only).
• When parameter KIND is assigned as SCC:
0=the office code is not allowed for the area code dialed.
1=the office code is allowed for the area code dialed.
ND-70348 (E)
RA
The details of this parameter are shown
below.
INPUT=Input office code can be
OFFICE
Enter the office code
ALL=All office code can be assigned.
ROUTE OFFICE CODE
(OFFICE)
ORDER 200-999
(RA)
0-7
EFFECT
OFLG
assigned.
OFFICE CODE DESIGNATING
FLAG(OFLG) DATA
INPUT/ALL (EFFECT)
CHAPTER 4
Page 277
Revision 3.0
ASDC