Aipdn: Assignment Of Ip Service Pad Data For Ndm - NEC NEAX 7400 IMX Command Manual

AIPDN: Assignment of IP Service PAD Data for NDM

1. General
This command is used to assign and delete the PAD data for IP service. It can also be used for reading out the
already assigned data to modify it. This data assigned by this command is written in the Network Data Memory
(NDM) of the Network Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. This command is valid when IPTRK service software is programmed.
2. PAD data of IP Trunk card can be assigned per Node as the pattern shown in the table below;
IC TERMINAL
Trunk
Analog Telephone/Dterm
ISDN Terminal
IPELC
IPTRK
3. If both "NODE" and "IPG" data for IC/OG Terminal parameter is restricted, this command cannot be used.
4. This command is available for the software Release 9 or later.
5. "IPG" parameter is available since Release 10 software enhancement.
OG TERMINAL
IPTRK
IPELC
Trunk
Analog Telephone/Dterm
ISDN Terminal
IPTRK
IPELC
Trunk
Analog Telephone/Dterm
ISDN Terminal
ND-70348 (E)
X: PAD data can be flexibly assigned by this command.
IC PAD OG PAD
X
PAD OFF
PAD OFF
X
X
X
X PAD OFF
X PAD OFF
X
X
X
X PAD OFF
X PAD OFF
DATA
X LGRT-Node
X Node-SFC
X Node-SFC
X IPG-Node
X IPG-IPG
X IPG-LGRT
IPG-SFC
IPG-SFC
X Node-Node
X Node-IPG
X Node-LGRT
Node-SFC
Node-SFC
CHAPTER 4
Page 647
Revision 5.0
AIPDN