Arac: Assignment Of Remote Access Code - NEC NEAX 7400 IMX Command Manual

ARAC: Assignment of Remote Access Code

1. General
This command is used when the system provides the Remote Access to System service feature for a TIE line or
DID line.
2. Precautions
1. The Remote Access to System service feature is activated when the access code (assigned at ACC param-
eter of this command) is called from a TIE line or a DID line. This command assignment is not required
when the Ring Down method incoming route is applied the Remote Access to System service feature.
2. The tenant number of the incoming trunk (ICTK) is assigned by the ATRK command.
3. The ACC should be assigned a unique number conformable to the station number (STN) assigned by the
numbering plan data.
4. When the ASYD command, INDEX43, bit0=0 (Authorization Code required with Remote Access to Sys-
tem service feature) is assigned, the AATC/AMND command should also be assigned. In this case, the TN
parameter of this command should correspond to the tenant number assigned by the AATC command.
5. To accomplish the Remote Access to System service feature, the following commands should also be as-
signed:
• ARTD command, FA=1
• ASTD command, STM=4, SYS=0, ST=1
• ACSI command
• ACFR command
• ARRC command
ND-70348 (E)
ARAC
CHAPTER 4
Page 290
Revision 3.0