Aisd: Assignment Of Individual Speed Calling Data - NEC NEAX 7400 IMX Command Manual

AISD: Assignment of Individual Speed Calling Data

1. General
This command is used to assign the speed dial number (of the Speed Calling - Station service feature) for a sta-
tion, instead of a station user's registration. This command also allows maintenance person to monitor present
user settings.
2. Precautions
1. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
2. The station number (STN) specified on this command should be assigned as a master station (MST) by the
AISA command.
3. The data range of the SPD parameter on this command is variable depending on the number of memory-
blocks assigned by the AISA command. (One memory-block contents ten memories which stores ten dif-
ferent speed dialing numbers)
3. Data Entry Instructions
STN
Assign the station number designated as a
master station (MST/SLV = M) by the AISA
command.
STATION
TENANT
NUMBER
NUMBER
(STN)
(TN)
1 2 0 0
SPEED
CALLING
DIGIT CODE
(SPD)
00-99
0 00
ND-70348 (E)
SPD
When assigning the parameter "BLOCK" = 1 in the
AISA command, assign any data in the range of 00-09 to
this parameter.
When assining the parameter "BLOCK" = 2 in the AISA
command, assign any data in the range of 00-19 to this
parameter.
The dial number to be transmitted by the
system when a station user dial "Speed
Calling-Station access code + SPD".
TELEPHONE NUMBER (TEL)
MAX. 18 DIGITS
TEL
1 2 3 4 5
CHAPTER 4
Page 550
Revision 3.0
AISD