Table of Contents
Advertisement
A-53
A-53
General Description
This feature provides both the Attendant and a user with dial access to multiple zone paging equipment.
Operating Procedure
To operate from a station
1.
The station goes off-hook; receives dial tone.
2.
The station dials the ALL-ZONE PAGING access code.
3.
Connections to multiple paging equipment are established.
Service Conditions
1.
This feature allows only Paging access. PAGING TRANSFER [P-10] and MEET-ME PAGING [M-11]
are not provided.
2.
A maximum of seven Paging Zones can be accessed simultaneously.
3.
When a user or an ATTENDANT CONSOLE [A-3] has a held station or trunk, this feature is not activated.
4.
If the Paging trunk is busy, the Paging connection is not established to the busy zone. PRIORITY
PAGING [P-30] access code + ALL-ZONE PAGING [A-53] access code dialing is possible. Even if this
dialing operation is performed, the PRIORITY PAGING [P-30] function is not activated when the line is
busy; i.e., it has the same result as ALL-ZONE PAGING access code dialing.
5.
One trunk circuit is required for each PAGING ACCESS [P-1].
6.
Amplifiers and speakers must be customer provided.
7.
Where TENANT SERVICE [T-12] is provided, separate access codes and hardware should be provided
for each tenant.
8.
The ALL-ZONE PAGING access code is three digits maximum. (Outgoing Call Alternative [OGCA])
9.
Both the COT card and the TLT card can be used as the paging trunk.
10.
Loop signaling is the recommended signaling type.
11.
This feature can be activated via FCCS.
Interactions
1.
MEET-ME PAGING [M-1, 11] and ALL-ZONE PAGING [A-53] can be provided simultaneously in the
same system.
2.
To directly answer ALL-ZONE PAGING by the Attendant Console, the Paged party should use the
INDIVIDUAL TRUNK ACCESS [I-4] feature.
3.
Paging is limited to stations, Attendant Consoles, or TIE Trunks. Other parties (CO trunk calls) must have
the Attendant Console or user perform the Paging operation.
4.
BUSY VERIFICATION [B-3], EXECUTIVE RIGHT-OF-WAY [E-1]: These features will be denied if
the Paging route has been assigned for Privacy. Verify the data in the Assignment of Route Data
command, ARTD, CDN 44:PRV. If TCL is assigned as Data 8, CDN 44:PRV is not required.
5.
For simple ALL-ZONE PAGING, assignments in ASFC are not required. Refer directly to the other
Paging service features, such as PAGING TRANSFER [P-10].
6.
The Attendant Console can dial Priority Page access code and release a station.
7.
When disconnecting from a Paging trunk, the trunk becomes idle immediately.
Page 48
All Zone Paging
All Zone Paging
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Advertisement
Table of Contents
