Adai_T: Assignment Of Terminal Application Data – Telephone Number - NEC NEAX 7400 IMX Command Manual

ADAI_T: Assignment of Terminal Application Data – Telephone Number
1. General
This command is used to assign application data for terminals by using Telephone Number and Logical Route
Number. The station data of ADAI command can be assigned by using Telephone Number instead. In addition,
the Route data can be assigned by using Logical Route Number (this function is available for Release 9 or later
software).
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case of logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. When logging in to the NCN, the data memory of the whole nodes with-
in the network can be written.
3. Prior to this command, logical route data must be allocated by using the ALRTN command.
4. Only when logging in to the NCN (Network Control Node), this command can be used to assign the logical
route data of self-Node and the other Nodes in the Netfusing network. If logging in to a LN (Local Node),
data setting just for the self-Node is available. (Error message is indicated if you try to write the data of
other Node.)
3. Data Entry Instructions
See the data sheet in section 4.
ND-70348 (E)
ADAI_T
CHAPTER 4
Page 570
Revision 3.0