Acnpn: Assignment Of Calling Number Pattern Data For Ndm - NEC NEAX 7400 IMX Command Manual

ACNPN: Assignment of Calling Number Pattern Data for NDM

1. General
This command is used to assign the Calling Number Pattern (CNP) to the route which is used for the SID To
Network-Present service/for the Calling Party Recognition service. The data assigned by this command is writ-
ten in Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local
Node (LN).
2. Precautions
1. Enter a B-Channel Logical Route Number in the LGRT parameter.
2. The CNP parameter in this command corresponds to the one assigned by ACNDN command.
3. Assign the Calling Number Pattern (CNP) to Incoming Call and Outgoing Call each.
4. When the Calling Party Recognition is used in TAPI service, this command is to be assigned to the incom-
ing route of COT which receives the calling number information from Central Office (analog) directly.
5. This command is available since software Release 7 or later.
6. This command must be used in a pair with ACNDN command.
3. Data Entry Instructions
I = Incoming Call (Calling Party Recognition)
O = Outgoing Call (SID To Network-Present)
KIND OF
CONNECTION
(IC/OG)
I/O
Enter the logical route number of the B-channel
IC/OG
LOGICAL ROUTE
NUMBER
(LGRT)
LGRT
ND-70348 (E)
CNP
Enter the arbitrary number within the range
between 1 and 1023.
CALLING NUMBER
PATTERN
(CNP)
1-1023
ACNPN
REMARKS
CHAPTER 4
Page 604
Revision 3.0