NEC NEAX 7400 IMX Command Manual page 514

CDN
TRUNK DATA
7 LLCRST Call Restriction by user rate in Low Layer Ca-
pability Information Element
0 = No restriction
1-31 = Call which includes this user rate value
Note:
8 VCM When assigning this data, zero (0) should al-
ways be entered.
9 OVRT When assigning this data, zero (0) should al-
ways be entered.
10 POOL When assigning this data, zero (0) should al-
ways be entered.
11 DTRT Deletion of ALL 1 alarm signal (DTI Layer 1
alarm)
0 = Not used
1 = Deletion of ALL 1 alarm signal as a Layer
1 alarm
12 TMPRT Temporary Route Information over CCIS
0 = Not used
1 = In CCIS, the route information can be
transferred by the call control messages.
Moreover, the call restriction can be
checked referring to this route informa-
tion.
13 CODEC When assigning this data, zero (0) should al-
ways be entered.
14 PASS When assigning this data, zero (0) should al-
ways be entered.
15 IRL Clear call when DTI alarm is detected
0 = Not used
1 = Clear call when DTI alarm is detected
Note
Note:
16 MTC Assignment of Timer T309 Value.
Restoration timer (TC×MTC) sec.
0-15 = TC×MTC (Restart timer value)
17 TC Timer T309 Counter Value
0 = Not used
2 = Not used
4 = 30 sec.
6 = 1 sec.
ROUTE NUMBER
Note
is restricted.
User rate value is based on
ITU-T Q-931.
This data should be set
when there is no Dch in the
physical DTI.
1 = 64 msec.
3 = 2 sec.
5 = 5 min.
7 = Not used
ND-70348 (E)
0 0
0 0
0 0
0 0
0 0
ARTI
0 0
0 0
0 0
0 0
0 0
CHAPTER 4
Page 500
Revision 3.0