NEC NEAX 7400 IMX Command Manual page 485

3. Data Entry Instructions
LANG
0=Common 1=Japanese
2=English 3=German
4=French 5=Spanish
6=Chinese 7=Russian
8-15=Spare
Note: LANG is available
for the Hotel application.
TENANT ANNOUNCEMENT
NUMBER EQUIPMENT
(TN) NUMBER
(EQP)0-127
Enter EQP as the service feature provided by DAT.
0=Dead Level Number
1=Unused Number
2=Remote Access to PBX
3=May be used for other purposes
4=Outgoing Trunk Busy Announcement
5-6=May be used for other purposes
7=Route Restriction Announcement
8-14=May be used for other purposes
15=Alert Service(for Hotel system)
16=Timed Reminder Set Message (for Business system)/
Service Set-up Message (for Hotel system)
17=Service Set-up Failure Message (for Hotel system)
18=Timed Reminder Cancel Message (for Business system)/
Service Cancel Message (for Hotel Massage)
19=Service Cancel Failure Message (for Hotel system)
20=Room Cut-Off Announcement (for Hotel system)
21=Do Not Disturb Announcement (for Hotel system)
22=Timed Reminder/Wake Up Call Message for Announcement Trunk
23-31=Group Announcement (for Hotel system)
32=Delay Announcement-Attendant (for U.S.A./Canada only)
33=Not Used
34=Automated Attendant (1st Announcement)
35=Automated Attendant (2nd Announcement)
36=Slumber Time-Do Not Disturb (for Slumber Time Group 1)
37=Slumber Time-Do Not Disturb (for Slumber Time Group 2)
38=Slumber Time-Do Not Disturb (for Slumber Time Group 3)
39=Slumber Time-Do Not Disturb (for Slumber Time Group 4)
40=Slumber Time-Do Not Disturb (for Slumber Time Group 5)
41=Slumber Time-Do Not Disturb (for Slumber Time Group 6)
42=Slumber Time-Do Not Disturb (for Slumber Time Group 7)
43-48=Not Used
49-53=Delay Announcement Attendant(1st Announcement)
54-58=Delay Announcement Attendant (2nd Announcement)
59-121=Not Used
122-125=Multiple Announcement
126-127=Not used
Note: When "M=0 (Single connection)" is selected, assign "R=1 (Do not send RBT)."
C
0=30 seconds, and then disconnects
1=The connection is held until the calling party released
0=Send RBT
1=Do not send RBT
KIND OF DURATION OF
CONNECTION
LANGUAGE
(C)
(LANG)
0-15 0/1
EQP
Note:
The EQP for Hotel system is
changeable by the AHSY command,
though the default EQP (service name)
are listed here.
Note
Note
Note
Note
Note
Note
Note
Note
ND-70348 (E)
A
R
0=Answer Signal is not sent
1=Answer Signal is sent
ANSWER
SENDING MULTIPLE
SIGNAL
RBT CONNECTION
SENDING
(R) (M)
(A)
0/1 0/1
0/1
0=Single connection
1=Multiple connection
RT
Enter DAT route number assigned
by the ATRK command.
ROUTE
TRUNK
NUMBER
NUMBER
(RT)
(TK)
M
TK
TK parameter appears
if M=1 is entered.
CHAPTER 4
Revision 5.0
AAED
Page 478