Afcp_T: Assignment Of Call Forwarding Service By Calling Number - NEC NEAX 7400 IMX Command Manual

AFCP_T: Assignment of Call Forwarding Service by Calling Number – Tele-
phone Number
1. General
This command is used to assign/delete the data related to the Calling Party Recognition Service of ISDN. The
station data of AFCP command can be assigned by using Telephone Number instead.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
3. When the Call Forwarding Destination is a trunk line, assign the Abbreviated Digit Code for the trunk line
using the ASPD command.
4. Data can be entered on a Day/Night basis if specified in the ASYD command, SYS1, INDEX 76, b2=1.
5. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.
6. The CALLING PARTY parameter may be treated as:
(a) All digits (Called Station Number + Access code assigned by the DC parameter of the ACND com-
mand + Calling Party Number)
(b) Some portions are ignored
Ignore 003, where 003 is the access code.
Example:
(c) The entire number is ignored, reverting back to traditional Call Forwarding services.
7. The Calling Party Recognition Service affects when the Bearer Capability of the calling party is "Speech"
or "3.1 kHz audio". ("Unrestricted digital data" is not available.)
8. This command is available since Release 8 software enhancement.
ND-70348 (E)
AFCP_T
CHAPTER 4
Page 609
Revision 3.0