Aarpl: Assignment Of Area Code Restriction Data For Ldm - NEC NEAX 7400 IMX Command Manual

AARPL: Assignment of Area Code Restriction Data for LDM

1. General
This command is used to assign the area/office code of Toll Restriction - 3/6 digits for Netfusing service con-
junction with ATDPL (for LDM)/ATDPN (for NDM) command. This data is written in Local Data Memory
(LDM). When common data is needed in the Netfusing Network, assign the data by the AARPN command.
2. Precautions
1. This command is used when restriction data is assigned to RES=2 (Toll Restriction is required) in the AR-
SCL (LDM)/ARSCN (NDM) command or in the ARRCN command.
2. This command is available since Release 7.5 software enhancement.
3. Data Entry Instructions
OG-LGRT
Assign a unique LGRT No.
in the Netfusing Network.
OUTGOING
LOGICAL
RESTRICTION
ROUTE
NUMBER
(OG-LGRT)
1-899
RSC assigned by the ARSCN command.
In case the data has already been assigned when "Get" button is executed after checking "6 Digits" pa-
Note:
rameter and entering DC=000000, "Del" button is not valid while "Set" button is to be effective. Then the
restriction data can be changed (overwritten) by "Set" button.
FLAG
Select either "3 Digits" or
"6 Digits" check box.
ROUTE
FLAG OF 3 OR
6 DIGITS
CLASS(RSC)
(FLAG)
0-15
3 Digits/6 Digits
RSC
0 = Area/Office code is restricted.
1 = Area/Office code is allowed.
DESTINATION
(AREA/OFFICE)
CODE (DC)
MAX .6 DIGITS
DC should not include the access code.
ND-70348 (E)
RES
RESTRICTION
REMARKS
DATA (RES) 0/1
DC
AARPL
CHAPTER 4
Page 305
Revision 3.0