Aani: Assignment Of Ani Data - NEC NEAX 7400 IMX Command Manual

AANI: Assignment of ANI Data

1. General
This command is used to assign ANI (Automatic Number Identification) data sent per tenant by the request from
opposite office.
2. Precautions
1. Before using this command, ASYD SYS1 INDEX 125 b4 - b7 (Type of MFC Signaling System) should
be assigned.
2. When ASYD command, SYS 2 INDEX 15, b2 = 1, the following number is sent as ANI data.
(a) Calling party is a station:
Calling party's station number is sent.
(b) Calling party is an Attendant or tandem connection:
"LDN" assigned in this command is sent.
If b2 = 0, "LDN" assigned in this command is sent.
3. The ANI parameter of ARTD command should be assigned prior to this command.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
3. Data Entry Instructions
This paramenter is not used. (For China only)
Press SPACE key and Enter key in order to skip
this parameter.
TENANT CALL NUMBER OF TOLL
NUMBER
(TN) MAXIMUM 8 DIGITS
TS
CALL NUMBER OF LOCALL
(TS)
(LS)
MAXIMUM 8 DIGITS
ND-70348 (E)
LS
If no LS (Local Number) of ANI is required,
enter "*" or "#" in this parameter.
The LS is not included in ANI.
LISTED DIRECTORY
NUMBER(LDN)
MAXIMUM 8DIGITS
AANI
REMARKS
CHAPTER 4
Page 587
Revision 3.0