Aarp: Assignment Of Area Code Restriction Data - NEC NEAX 7400 IMX Command Manual

AARP: Assignment of Area Code Restriction Data

1. General
This command is used to assign the area/office code of Toll Restriction - 3/6 digits conjunction with ATDP com-
mand.
2. Precautions
1. This command is used when restriction data is assigned to RES=2 (Toll Restriction is required) in the
ARSC command or in the ARRC command.
2. This command is available since Release 7.5 software enhancement.
3. Data Entry Instructions
OUTGOING
RESTRICTION
ROUTE
NUMBER
(OGRT)
RSC assigned by the ARSC command.
Note: In case the data has already been assigned when "Get" button is executed after checking "6 Digits" pa-
rameter and entering DC=000000, "Del" button is not valid while "Set" button is to be effective. Then the
restriction data can be changed (overwritten) by "Set" button.
FLAG
Select either "3 Digits" or
"6 Digits" check box.
ROUTE
FLAG OF 3 OR
6 DIGITS
CLASS(RSC)
(FLAG)
0-15
3 Digits/6 Digits
RSC
0 = Area/Office code is restricted.
1 = Area/Office code is allowed.
DESTINATION
(AREA/OFFICE)
CODE (DC)
MAX .6 DIGITS
DC
DC should not include the access code.
ND-70348 (E)
RES
RESTRICTION
REMARKS
DATA (RES) 0/1
Revision 3.0
AARP
CHAPTER 4
Page 304