Ancd_Lr: Assignment Of Night Connection Data – Logical Route Number - NEC NEAX 7400 IMX Command Manual

ANCD_LR: Assignment of Night Connection Data – Logical Route Number
1. General
This command is used when the Power Failure Transfer (PFT) circuit card is controlled by the external key.
Route data of the ANCD command can be assigned by logical route number.
2. Precautions
1. Prior to this command, logical route data must be allocated by using the ALRTN command.
2. Only when logging in to the NCN (Network Control Node), this command can be used to assign the logi-
cal route data of self-Node and the other Nodes in the Netfusing Network. If logging in to a LN (Local
Node), data setting only for the self-node is available. (Error message is indicated if you try to write the
data of other Node.)
3. When the "PFT control by the external key" is required, the following data assignments are needed:
(a) AUNT command, TYPE = 2 (PFT)
(b) AEKD command
(c) ANCD/ANCD_LR command
(d) ACSI command, CSI = 4 (Direct-in Termination (Night Mode))
4. This command is available since Release 9 software enhancement.
3. Data Entry Instructions
Enter the data of PFT card assigned by the AUNT
command.
FUSION
MODULE
POINT
GROUP
CODE
NUMBER
(FPC)
(MG)
1-253
FPC
Enter the FPC of target Node only when logging
in to the NCN (Network Control Node).
The port parameter corresponds to the circuit
number of the PFT card.
MG
PORT
NUMBER
PFT CARD
OF PFT
NUMBER
CARD
(NCU PKG)
(PORT)
0-3
0-11
PORT
ND-70348 (E)
Enter the logical route number allocated to the
external route number.
LOGICAL
OUTSIDE
ROUTE
ROUTE
NUMBER
NUMBER
(LGRT)
(RT)
1-899
Enter the trunk number connected to the corresponding
circuit number of PFT card.
ANCD_LR
LGRT
TRUNK
NUMBER
REMARKS
(TK)
1-255
TK
CHAPTER 4
Page 581
Revision 3.0