Artdn: Assignment Of Route Class Data For Ndm - NEC NEAX 7400 IMX Command Manual

ARTDN: Assignment of Route Class Data for NDM

1. General
Using this command, all logical route data of all Local Node (LN) may be displayed and charged at Network
Control Node in the Netfusing Network.
2. Precautions
1. The ARTDN command should be assigned for all logical trunk routes and the dummy logical route for
LCR/LCRS.
2. The Logical Route Class data assigned by this command is also allocated to Route Class data (ARTD). If
the Logical Route Class data is deleted by using this command, however, the Route Class data is not to be
deleted. Therefore, use ARTD command to invalidate the Route Class data.
3. The standard route class data is shown in the example. (which is listed after the parameter descriptions)
4. Parameters TCMN through MT are effective only when 4 (MF) is assigned to parameter ONSG or INSG.
For all other logical trunk routes, assign "0" to all of these data.
3. Data Entry Instructions
See Data Sheet on the following pages. For examples of data assignment, see Table 4-23
ND-70348 (E)
ARTDN
(page 427)
.
CHAPTER 4
Page 411
Revision 3.0