Acsi: Assignment Of Connection Service Index Data - NEC NEAX 7400 IMX Command Manual

ACSI: Assignment of Connection Service Index Data

1. General
This command is used to assign the call termination for Direct-in Termination (Day and Night), Night Connec-
tion and Remote Access to System.
2. Precautions
1. The ACFR command assignment is also required to assign the trunk incoming call termination service fea-
ture.
2. When setting the CSI to "6" (Night Connection-Outside) or "7" (Direct-in Termination-Outside) using this
command, the ADC must be set by the ASPD command.
3. Use the ACSA command instead of this command if Direct-in Termination (Day mode only) is required.
4. When the "PFT control by the external key" is required, the following data assignments are needed:
(a) AUNT command, TYPE=2 (PFT)
(b) AEKD command
(c) ANCD command
(d) ACSI command, CSI=4 (Direct-in Termination (Night Mode))
5. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. Enter
the tenant number in which this command effects.
If CSI=4 "Direct-In Termination (Night Mode)" is to be assigned in the ACSI command, CCI=1 & CCI=4
Note:
for TSFI=2 must be set to data "1 (allowed)" in the ACFR command.
ND-70348 (E)
Note
ACSI
CHAPTER 4
Page 576
Revision 4.0