Aosp: Assignment Of Outgoing Selection Pattern - NEC NEAX 7400 IMX Command Manual

AOSP: Assignment of Outgoing Selection Pattern

1. General
This command is used to assign skip and additional digits information for Outgoing Selection Translation Pat-
tern Number (PNO).
2. Precautions
1. Before using this command, make sure that an Outgoing Selection Translation Pattern Number (PNO) has
been assigned in the ASTP command.
2. The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTP/AOSP com-
mand. Since the additional number and skip digits can be assigned by the AOPR/AADC command for
LCR/LCRS method, the ASTP/AOSP command may not be required.
3. Data Entry Instructions
Enter the PNO assigned by the ASTP command.
OUTGOING SELECTION
TRANSLATION PATTERN NUMBER
(PNO)
1-15
Enter desired skip digits if required
PNO
NUMBER OF DIGITS
SKIPPED
(SKIP)
0-24
SKIP
Enter the number of digits to be entered in DC parameter.
NUMBER OF ADDITIONAL
DIGITS
(ADD)
0-4
Enter desired additonal numbers within 4 digits.
ND-70348 (E)
ADD
ADDITIONAL DIGIT INFORMATION
(DC)
MAXIMUM 4 DIGITS
DC
CHAPTER 4
Revision 3.0
AOSP
Page 254