13. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
14. There is no default key data provided for D
tons must be programmed. When assigning the key data of the line/feature button, take the following pre-
cautions:
(a) My Line Key must be assigned in KYN = 1-8, and KYN = 9-16 should be assigned KYI = 0 (Not
used).
(b) The following function keys are basically fixed:
FKY = 13:CONF (Three-Way Calling)
FKY = 18:TRANSFER (Call Transfer-All Calls)
FKY = 20:HOLD (Non-Exclusive Hold/Exclusive Hold)
FKY = 28:ANSWER
FKY = 51:MIC
FKY = 52:SPEAKER
FKY = 57:RECALL
(c) Not used line/feature buttons should be assigned KYI = 0 (Not used).
15. There is no default key data provided for D
line/feature buttons must be programmed. When assigning the key data of the line/feature button, take the
following precautions:
(a) My Line Key must be assigned in KYN = 1-24, and KYN = 25-40 should be assigned KYI = 0 (Not
used).
My Line in KYN = 17-24 cannot be assigned without assigning any Line Key or any Function Key in
KYN = 1-16.
(b) The following function keys are basically fixed.
FKY = 13:CONF (Three-Way Calling)
FKY = 18:TRANSFER (Call Transfer-All Calls)
FKY = 20:HOLD (Non-Exclusive Hold/Exclusive Hold)
FKY = 28:ANSWER
FKY = 51:MIC
FKY = 52:SPEAKER
FKY = 57:RECALL
(c) Not used line/feature buttons should be assigned KYI = 0 (Not used).
term
(8-button type). The key data for all the line/feature but-
term
(24-button type/32-button type). The key data for all of the
ND-70348 (E)
AKYD_T
CHAPTER 4
Page 352
Revision 3.0